|
 Tools Required (not provided):
2 x 3/4" wrenches
1 x 1/2" wrench
1 x 9/16" wrench
1 pair of needle-nosed pliers
Parts List (provided):
1 x ring
1 x log rack (contains 2 x all-threads)
4 x legs (each identified with colored dots)
4 x wheels
8 x 5/16" x 3/4" bolts
8 x small acorn nuts (5/16")
4 x large acorn nuts (1/2")
4 x cotter pins
Assembly Instructions:
Set ring on table at good working height. Ring doesn't have a top or bottom. Attach red dot legs to red dot on outside of ring, bolting from the inside to a small acorn nut on the outside of ring. Finger tighten only. Repeat using second bolt and small acorn nut.
Again, working on the outside of the ring, repeat with green dot legs to green dot on ring, using bolts and small acorn nuts provided.
At the other remaining hole in each leg, assemble the log rack using the all-thread provided, and attach using each of the 4 large acorn nuts. Finger tighten.
Slot the wheel onto the leg axle, and drop a cotter pin through each axle hole then use pliers to spread pins in opposite directions to secure wheel.
Place oven stand upright, on its wheels, and fully tighten all nuts and bolts with wrenches. When you have it situated where you want it, place a block next to the wheels, to ensure the stand does not move while placing the oven on to it. Oven opening should be positioned to line up with ''front' of oven stand, in line with wheels.
Any questions? Call our toll free #: (866) 305-2675.
|
| 
